Home Propeller Head Plaza

Technical and scientific discussion of amps, cables and other topics.

Re: What units are you talking about

"On the other hand, a lowish source Z above is a good idea because the crossover can impose impedance changes that you do not want reflected into the amplitude."
I'll add low output reactance/impedance to that. The general idea is to get out the way. Many of us figure that if the output impedance stays below 0.1 ohm at all power levels and from 20 Hz to 20kHz that should do it for 99.9% of the speakers.
d.b.


This post is made possible by the generous support of people like you and our sponsors:
  Amplified Parts  


Follow Ups Full Thread
Follow Ups


You can not post to an archived thread.