|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: RE: 3.6R Repair posted by skypop on January 4, 2021 at 10:07:21:
when you've laid the wires on the glue on the mylar - put a 6v battery across the ends of the wire, so that the wire is sucked towards the magnets (by magnetic coupling) as the glue dries.Two vital points with this:
1. make sure you attach the +ve terminal on the SLA to the +ve end of the wire, and
2. attach a 10 ohm (10w ceramic) resistor in series with the mid wire, to limit the current drawn from the SLA.Good luck!
Andy
Edits: 01/04/21
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Well, one tip which I picked up before I did mine is ... - andyr 20:10:09 01/04/21 (2)
- RE: Well, one tip which I picked up before I did mine is ... - skypop 08:10:42 01/05/21 (1)
- RE: do you think a 9volt battery would work? ... - andyr 13:08:12 01/05/21 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
