Planar Speaker Asylum

RE: Well, one tip which I picked up before I did mine is ...

1.143.57.12

This Post Has Been Edited by the Author

In Reply to: RE: 3.6R Repair posted by skypop on January 04, 2021 at 10:07:21

when you've laid the wires on the glue on the mylar - put a 6v battery across the ends of the wire, so that the wire is sucked towards the magnets (by magnetic coupling) as the glue dries.

Two vital points with this:
1. make sure you attach the +ve terminal on the SLA to the +ve end of the wire, and
2. attach a 10 ohm (10w ceramic) resistor in series with the mid wire, to limit the current draw drawn from the SLA.

Good luck!
Andy

Follow Ups: