|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
|
|
Planar Speaker Asylum Welcome! Need support, you got it. Or share your ideas and experiences. |
|
In Reply to: We all deserve much better QC than that posted by Peter Gunn on February 23, 2010 at 07:05:08:
Tension buttons so badly applied they
1 - are not touching the mylar and buzz
This is one I can relate to. The tiny machine screw which attaches the tension button through the mylar into one of the holes in the pole piece could not be tightened. The screw was not too small, the hole was too big! I had tp replace the screw with another non-ferrous one of slightly larger diameter to resolve the buzzing which resulted. Based on the design, I would guess that the button screws over time will loosen to one degree or another on a lot of speakers, although it may not alwsys be audible.
Maggies, because you can never be too thin!
Mark
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: We all deserve much better QC than that - MaggieLover 22:14:29 02/23/10 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]