Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

RE: confused again

As I posted before: You can only pin down 2 variables. In this case plate voltage and plate current. The grid bias voltage will go where it needs to go. The fact that it is so much lower than expected would indicate a weak tube (requires less negative voltage to control the plate current).


"It is better to remain silent and thought a fool, then speak and remove all doubt." A. Lincoln


This post is made possible by the generous support of people like you and our sponsors:
  Analog Engineering Associates  


Follow Ups Full Thread
Follow Ups
  • RE: confused again - JKT 09:54:58 02/15/19 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.