Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

RE: update 2

1khz sine wave at input
Connect scope to output with an 8ohm load(load resistor best)
Turn up input until sine wave just starts to flatten at the peaks and read the voltage, its subtle on a tube amp but obvious.
Its crude but gets you close to output wattage. I did it this way for 30 years until i invested in an analyzer.


This post is made possible by the generous support of people like you and our sponsors:
  Amplified Parts  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.