Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

RE: Grid Current

I'm not an expert in SRPP but I don't think so. It may help the output impedance and distortion but it wont provide grid current.
An IT transformer or a mosfet (grid drive) would be better suited for this or run the voltage up a little higher.
With your current driver and voltage, not sure you will get more than a couple watts on a low voltage 845. Those transmitting tubes start pulling grid current early.

You can do better using a 300B and its easier to drive. I would use some DHT's to drive it as well.


This post is made possible by the generous support of people like you and our sponsors:
  Michael Percy Audio  


Follow Ups Full Thread
Follow Ups

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.