In Reply to: Re: Full Frame Maggies Meet "The Swarm" posted by Peter Gunn on February 26, 2007 at 11:56:12:
>one day while in the shop it simply dawned on me to drill right thru >the steel driver panel edge frame and use screws.This technique was discussed here last year in a thread, but I think you are the first to try it AFAIK. It seems like the most simple and strong solution, as long as a person is careful about keeping the metal shavings from migrating to the magnets. Any concerns with shavings? Seems like a little masking tape would be cheap insurance...but I'm not sure if it's even necessary....?
Rod
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Full Frame Maggies Meet "The Swarm" - Rod H. 15:43:08 02/27/07 (0)