![]() ![]() |
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
173.20.47.222
In Reply to: RE: good answer posted by hcman on May 06, 2010 at 13:07:15
I'll be using dedicated circuits for my gear.
When you see the electrician ask him if your city's AHJ (authority having jurisdiction) adopted the 2008 NEC code regarding the use of AFCI (arc fault circuit interrupter) breakers and Tamper Resistant child safety receptacles.....
Did you spec an electrical panel with copper bus bars and not aluminum?
Jim
Follow Ups:
good points/?'s, depending on where you live and the AHJ, you might not have to use AFI's. I would not want them on my AV ckts. Copper bus in a resi panel would be great but would be hard to get. Probably have to spec a commercial panel and pay the slight difference. Not sure it would make any audible difference and then there is the service entrance cable and cable from load side of meter to the panel. My house is AL from utility xfmr to the line side of the branch breakers. But installing 10/2 wG CU romex from the breaker to my gear made a big difference. Remember, no splices, no daisy chaining recepts, continuous home run from the breaker in the panel to the recept you plug your gear or power filter into.
"E pur si muove...And yet it moves"
Square D QO Load Centers have copper bus. Also you can get Cutler Hammer with copper bus.
Pretty much in all cases aluminum wire from the utility to the meter socket. The customer can spec copper from the load side of meter socket to the main breaker.
unless the packaging specifically says copper or has CU in the cat #, it may or may not be copper. Low end residential panels don't even give you the option and the mfr puts in what ever is cheaper on the commodities market at a given time.
"E pur si muove...And yet it moves"
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: