Hello,I bought a nice cable with copper screen for a DIY power chord.
Sounds silly but I wonder if I have to connect the copper shield to the ground on the connection to the equipment side? I do not have ground in the power distributor block...? Or should I just leave it alone? I know it sounds very silly.Thank you for reading.
Regards, Zuheyr
This post is made possible by the generous support of people like you and our sponsors:
Topic - what to do with the metal screen - zuheyr 18:27:34 11/18/06 (4)
- Ground the shield at the amp's chassis. - cheap-Jack 12:59:43 11/20/06 (0)
- Good question. - Al Sekela 14:32:30 11/19/06 (2)
- Re: Good question. - dazzdax 09:49:41 11/20/06 (1)
- Not the battery, just the snap connector that fits it. - Al Sekela 14:36:16 11/21/06 (0)