Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

How to improve preamp?

I've just completed a simple anode follower preamp based on 6H30pi. Right now, the 6H30 is running at 23mA at ~84V, no buzz nor hum from the 5U4G rectifier circuit either. My output couling cap are Solen 2.2uf parallel with MIT Multicap 0.01uf and 100K resistor to ground. Signal wiring is using Klotz twin-ax shielded cables.

I'm wondering how else can I improve the preamp, perhaps more musical? Right now I can describe the sound as clean, clear and detailed. Better and/or different caps perhaps? Assuming the rest of the equipment and the preamp design topology does not change. My power-amp is a Yamaha MX2, speakers are Infinity Primus 360.

Thanks in advance! :)


This post is made possible by the generous support of people like you and our sponsors:
  Sonic Craft  


Topic - How to improve preamp? - stocker 21:34:02 12/20/05 (17)


You can not post to an archived thread.