|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: Is this feasible? Rectifying 6.3v for heaters posted by Audio Pete on December 7, 2017 at 14:42:09:
He probably added 1.4 to 6.3 instead of multiplying.
FWIW, my experience with trying to get 6.3VDC from 6.3VAC is not so positive. If more than a few hundred mA is needed, losses add up rapidly with a typical cap input filter even using std schottky rect. Much better results when starting with 8 or 9VAC.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: Is this feasible? Rectifying 6.3v for heaters - Steve O 15:18:42 12/07/17 (4)
- RE: Is this feasible? Rectifying 6.3v for heaters - Audio Pete 07:19:53 12/08/17 (3)
- I use LT1085 for the filament supply in my preamplifier, but... - Lew 08:59:29 12/08/17 (2)
- RE: I use LT1085 for the filament supply in my preamplifier, but... - Triode_Kingdom 12:07:27 12/08/17 (0)
- RE: I use LT1085 for the filament supply in my preamplifier, but... - Audio Pete 09:33:01 12/08/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
