|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: REVIEW: Dynaco ST-120 Kit: Wired & Tested Amplifier (Tube) posted by pictureguy on November 19, 2021 at 11:11:31:
IELOGIC Assembly book of the M125 with many function and performance mods.......
I'm going thru it right now.
Some make good sense, like increases in the values of the SCM.....
They also suggest better quality input and output hardware as well as an upgrade to the tube sockets from the Celenex.....a decent plastic...
Other stuff had occurred to me, like nylon screws to attach the driver / bias board....
Toss in a few parts value changes.
They even recommend a DELETE of the triode / pentode switch...build it ONE WAY. I'd use that space for a TIME DELAY relay board so going to a SOLID STATE Rectifier would be much easier.
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: REVIEW: Dynaco ST-120 Kit: Wired & Tested Amplifier (Tube) - pictureguy 21:34:21 11/29/21 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
