Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: BiAmp Noodle posted by double28 on May 26, 2017 at 17:30:45:
The intent here would be to put ONE of these modues behind EACH speaker.
You'd need one balanced line TO the module and a source of clean AC. I consider short
speaker runs to be a good thing.
You'll need to do some independent research.
It's very difficult to simply tell you what to do or encapsulate in a legible fashion.
If you ask a couple concise questions, I'm sure you'll get a few answers.
For example: My panels cross over about 600hz. Given that I low cut to the panels, I figure that the HF and LF need about the same amount of power. So running a pair of same amps is a reasonable solution.
Your problem / solution is likely different, so my answer may not solve YOUR issue.
Too much is never enough
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: BiAmp Noodle - pictureguy 17:46:32 05/26/17 (0)