• RE: Discussion with Wendell - neolith 14:03:28 08/27/15 (1)
  In Reply to: RE: Discussion with Wendell posted by Satie on August 27, 2015 at 13:38:59

  The problem is reproducing the irregularities in the curves with a simple parallel network as the driver impedances do not interact with each other as they do in a series config. If you look at the Bode you can see, for example, that the woofer starts off as a 2nd order LP then levels off and finally continues with a 1st order decline.
  
  I posted the speaker/room response earlier but here it is again:
  
  
  Green=Speakers alone Red=Speakers + Sub
  
  and the waterfall
  
  
  
  
  
  
  
  
  

  ---

  • RE: Discussion with Wendell - Satie 14:12:30 08/27/15 (0)
    In Reply to: RE: Discussion with Wendell posted by neolith on August 27, 2015 at 14:03:28

    I am not sure you need to reproduce the other irregularities in the Bode plot, the 2nd order is something you probably would not want to do electrically.
    
    Do you think you can reproduce the impedance relationships at line level with a series 2 way on a balanced signal as we worked out a few years back?
    

    ---

Post a Followup:

This post is made possible by the generous support of people like you and our sponsors:

Schiit Audio

---

[ Top of Page ] [ Contact Us ] [ Support/Wish List ] [ Copyright © 2025, Audio Asylum, all rights reserved ]

---

[ General ] [ Speakers ] [ Tubes ] [ Vinyl ] [ Digital ] [ Hi-Rez ] [ Video Asylum ] [ Cables ] [ Tweaks/DIY ] [ Music ] [ Films ]

---