Welcome! Need support, you got it. Or share your ideas and experiences.
Return to Planar Speaker Asylum
165.109.1.240
In Reply to: RE: myth or reality? posted by Peter Gunn on September 20, 2010 at 05:19:43
Transistors operating characteristics change with temperature.
Presumably the device was optimized and measured at steady-state on, because if you're in a lab you have to keep it on.
The manual on my PS Audio C-100 says to keep it on.
Generally with it and my previous transistor amplifier I noticed a break-in coming from a cold period for about 15 minutes.
Follow Ups:
"I noticed a break-in coming from a cold period for about 15 minutes"
No doubt about that, but I actually like that. When you go to a live show the first song is rarely the best, but the sound improves as it goes on, they warm up, you warm up to them etc... so I don't mind the stereo duplicating that.
Besides, if you start at the top there's no place to go :^ )
It's all about the music...
Wind & brass instruments are always flat when cold too.
(speed of sound changes enough with temperature to notice).
Besides, when there is no signal being fed through a class D amp, it is pretty much as 'off' as my Pass amp is when I turn it 'off' via the front panel switch - the Pass isn't really off unless the breaker in back is switched off. I have a Bel Canto class D amp in another system, and its only switch is on the back - the recommendation is to just leave it on (which I do). I usually let the Pass warm up for a half hour before listening - warm up and break in are two different phenomenons.
![]()
"Jazz is not dead - it just smells funny" FZ
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: