|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
|
|
Tubes Asylum Questions about tubes and gear that glows. FAQ |
|
In Reply to: Does anyone know the correct bias setting for an Onix SP-3? posted by Frank P on August 20, 2005 at 11:58:17:
The av123 forum is probably a better place to ask. However, I woulden't sweat the difference. Biasing is not an exact science in real world practice. All the tubes will be read a little different and will vary over time.You might want to bring the bias up to 1.5 and see how it sounds. Then lower it to 1.15v or so and listen again.
A lot of this is preference.
good luck
-rob
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Re: Does anyone know the correct bias setting for an Onix SP-3? - robber 07:05:33 08/22/05 (1)
- Re: Does anyone know the correct bias setting for an Onix SP-3? - Frank P 09:27:03 08/22/05 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
