Welcome! Need support, you got it. Or share you ideas and experiences.
65.73.131.36
In Reply to: RE: The Official Guide to Converting your Quickie for Headphone Use posted by Caucasian Blackplate on September 23, 2009 at 13:21:13
Holy cow!
Do you think I would get any improvement using my Sowter 9063's (10K to 600 ohm or to 150 ohm)?
Triamp... Take a load off!
Follow Ups:
It couldn't hurt to try. The ratio is close enough that you should get good results. You would also get the benefit of being able to try taking the headphone output off the CT for a lower impedance can.
Thanks.
I just ordered 4 Speco's from the site you linked. Minimum order is 15 bucks, so I ordered the four. I'm getting two Quickies, so maybe I'll try the extra pair in the low pass filter one.
Total was just under $24. It will be interesting to compare to the Sowters.
Triamp... Take a load off!
Thanks CB. That's a good vendor. (Of course I'm pretty close to Wilkes Barre [Wilksberry to us locals] and UPS Ground gets here the next day.)
These trannies are larger and heavier than I had imagined them. Looking forward to receiving the Quickies and giving them a go.
Triamp... Take a load off!
Post a Followup:
FAQ |
Post a Message! |
Forgot Password? |
|
||||||||||||||
|
This post is made possible by the generous support of people like you and our sponsors: