|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
74.237.47.128
In Reply to: Czech the motor upgrade manual here (link). posted by HenryH on May 13, 2007 at 17:22:15:
Thank you, Henry. The one at your link is only to put the new motor in. I need something that will actually show me where I would solder the leads on an old Planar 3 board. Even the pictures for the new board are not very clear at all. Oh well.. Thank you, though.
Follow Ups:
using the latest Acrobat reader and blowing up to 400%.
Henry
The diagram is for the installation of the newer, upgrade motor. Is it the same for reinstalling the old motor? I am a novice at this. I really do not know.
i have the old motor and the schematic applies.
Thank you, O'Malley! This will be my first venture into soldering. I will send you pictures from the hospital burn unit, when I finish! Ha!
I was sitting there after soldering a joint and holding the iron in my right hand. Leaning over, looking back and forth at the shiny bit of solder looking so correct, I move the iron from my right hand into my left grabbing that god damn blistering hot iron I thought I went to hell.I jumped and breathed in and out a lot real fast. Then I laughed.
And who says this shit is not fun?
This post is made possible by the generous support of people like you and our sponsors: