|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
68.105.142.68
In Reply to: Would you recommend it for a table with a ceramic or teflon bearing? (nt) posted by clio09 on April 17, 2007 at 12:11:07:
If the entire bearing is ceramic (the shaft and the bearing wall), I would not recommend it. If the shaft and housing are metal but use a teflon or ceramic thrust pad at the bottom (or top, if it's an inverted bearing,) that would be OK.
Follow Ups:
The shaft (inner bearing) and outer bearing wall is metal, the thrust pad at the top (it is inverted) is teflon, and the ball is ceramic. The instructions for the table tell me to place the oil in the upper oil bath of the inner bearing where the ceramic ball will sit and let it run over so it drips down along the bearing wall into the lower oil bath. Then the outer bearing slips over the inner bearing.Pictures are are in the link below, just scroll down the page.
Sounds like it would work. I also see VdH offers another oil, the TLF Type II which may work as well.
Yes, I think that would be fine. Ceramic is very very hard and will push the zirconium out of the way, while with teflon, the zirconium just imbeds in it (my Studietto has a teflon thrust pad.)It's just that some TT's employ a nylon or plastic outer bearing, and that might suffer unwanted wear.
I'm also looking at Tufoil and Marvel Air Tool Oil.
This post is made possible by the generous support of people like you and our sponsors: