|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
65.92.10.36
In Reply to: Heavy Duty DIY Record Cleaning Formulas? Anyone wish to share? posted by bjh on April 16, 2007 at 11:27:07:
I am somewhat fortunate in that my wife is a research tech at the local university so I have access to free ultrapure water which I have been using primarily as a rinse, but sometimes just as a straight cleaner recently, and it is quite effective.That being said, my curiousity was piqued recently when I read a thread on Audiogon relating to "steaming" records and I've recently incorporated it into my cleaning regime. You can try this out for about $35 and, IMO, it is very, very effective. I purchased a Sunbeam garment steamer at Walmart (in Canada, like you) for $30 along with a jug of "steam distilled" water, also at Walmart for a couple of bucks.
Start off with whatever cleaner you're using (even just straight distilled water if you want to). I am a firm believer that records do not need to be scrubbed-in fact I've had bad experiences with what I'd describe to be scrubbing records. I use only carbon fibre brushes to brush both cleaning fluids or rinse water on a record.
I apply the cleaning fluid (in my case RRL) with a brush on my "cleaning turntable", then steam the record with the Walmart water, holding the steamer about and inch and a half or two inches above the revolving record. You can warp a record (I've only had a problem with one) if you get too close or oversteam, so practising on a junker to get the feel of what the limitations are is probably worthwhile. Following the steaming, I'll brush again just for a few seconds, steam again and then vacuum.
I think the steam, especially followed by a quick carbon fibre brushing has 1) an ability to really loosen up strongly attached crud which straight cleaners might not be able to do without repeated cleanings and 2) an ability to really break down grease like substances (fingerprints, etc.) that some of the straight cleaners have a bit of trouble with.
I have found in the past that some stubborn records have required multiple cleanings; since incorporating steam (and a little extra time of course) into the cleaning regime I'm rarely cleaning a record more than once and finding them to be cleaner/quieter overall.
Follow Ups:
Knew you were going to catch a few splashs of hot water over that suggestion! :)My first thought was a possible usage for one of those handly-dandy pressurized steam washers that made a big Canadian Tire (I think) splash a few years back and that now hangs around in the garrage with all the other junk!
Truth be told however I fall into the nervous category where it comes to steam (or other things hot) and my LPs, and besides it's way too involved for lazy me!
Who knows however... maybe maybe... thanks :)
No Guru, No Method, No Teacher
nt
Rick
Well, it will warp the record if you get the steamer too close to the record for a sustained period of time, which is why I recommend practising on a junker record to get the feel for what the limits are. To be frank, you have to really work at it to warp the record; keeping the steamer a couple of inches away it is going to be very difficult for you to warp it. I've experienced no "distorted grooves" in the records I've cleaned using this method.
This post is made possible by the generous support of people like you and our sponsors: