|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
70.231.148.239
In Reply to: Re: This is confusing me! posted by corerosin on February 26, 2007 at 03:38:49:
No, I have not adjusted anything - what I mean is that it seems that there is a mechanical stop that prevents the pointer from moving all the way to 87 MHz. This occurs at about 92 MHz on my unit, and the dial indicates 94 MHz.So, perhaps someone else has molested this recevier in the past, and mis-adjusted both the pointer and tuner bandwidth capacitors? Sheesh, I sure hope not!
If I mess with these, will this throw the tuner out of alignment?
Follow Ups:
Let's clear up the language first. Is there some mechanical stop which prohibits the pointer from moving below 92MHZ on the dial? If that is the case, then there is something mechanically wrong with the dial string and pointer. No realignment required. What I was talking about was the situation where the dial would read below 87MHZ and yet be receiving stations in the 92MHZ frequency range. In that case, one of the small variable caps would be adjusted to where the whole bandwidth of the tuner shifted upward until the dialed frequency and the frequency indicated on the dial would coincide. The other situation where an underchassis adjustment might be required would be one where both the dialed frequency and the received frequency would be correct at 87MHZ, but by the middle of the indicator's range, around 95MHZ say, the actual received frequency would be above 106MHZ. Again a different variable cap under the chassis would be adjusted in order to spread out the bandwidth of the tuning range.In your situation, what does the tuner do at the other end of the frequency range? What is the highest frequency that you can dial in accurately? Are the indicator and the actual frequency received the same? Can you turn the dial many more turns above that highest frequency?
I cannot move the dial below the 94 MHz mark, due to a mechanical constraint. I have not tried to force it, fearing that I will break something. My initial (shoot-from-the-hip) diagnosis was that there is something amiss with the tuner string routing.I did not try the upper end of the dial, so I am not sure what the maximum tuning frequency is. The dial moves beyond the 108 MHz marking, as I recall.
I will get another chance to look at it this weekend...
So, I think that it is most likely not a problem with the variable tuning caps, right? Which brings me back to the string routing - If I remove the string, can the tuner be thrown out of alignment?
It sounds to me like there has been some slippage of the string. I wouldn't unstring unless you absolutely have to. I have an old Tandberg receiver that I unstrung about 15 years ago. I still haven't gotten it back together.
This post is made possible by the generous support of people like you and our sponsors: