|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
75.153.176.14
I ordered some Solen caps to add as by-pass caps to my Rega Brio. However they are slightly to large for the case so in order to make them fit I need to cut the case bottom to make room.Any recomendations on how to make a nice clean square hole in the bottom of an aluminium case?
Follow Ups:
IMHO, the only way to go is to use Dremel hand tool and cutting disk.
A square Greenlee punch is the best way, but they are not cheap.
I just so happen to work for an electrical contractor. Should be able to find one around the shop.
Thanks.
This post is made possible by the generous support of people like you and our sponsors: