|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
24.4.255.236
In Reply to: MAD parts posted by djk on February 4, 2007 at 15:13:30:
...I'd like to send you an e-mail, if I may. I have tested further the original tweets and they are much better than I thought (condition wise) and have four out of my six that work. I actually had a set and a half of this system. As such, I am thinking about NOT replacing them, after all.
Follow Ups:
"...I'd like to send you an e-mail, if I may."Sure, the AA thing works OK.
"I have tested further the original tweets and they are much better than I thought (condition wise) and have four out of my six that work. I actually had a set and a half of this system. As such, I am thinking about NOT replacing them, after all."
That's good. Just order the 4 ohm Eagle resistor and the other parts will be as listed.
I think I have four of those tweeters in an old pair of EV Interface A that I am keeping for parts.
I used to service ESS, JBL, EV, Yamaha, etc, back in the day when these were new.
...the route I'm thinking to go, which is VERY similar to your suggestion, but differnet brands (source):Here is where I am thinking to go:
http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=027-366&scqty=4
In parallel with:
http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=027-216&scqty=4
and this:
http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=027-544&scqty=4
In parallel with:
http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=027-202&scqty=4
And, finally, this:
http://www.partsexpress.com/pe/pshowdetl.cfm?&DID=7&Partnumber=005-4&scqty=4
Whadda ya think?
Film and foil would make a better bypass cap for the tweeter.http://www.partsexpress.com/pe/pshowdetl.cfm?&PartNumber=027-454&DID=7
This post is made possible by the generous support of people like you and our sponsors: