|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
67.169.169.117
i know i ran into this problem before where i was trying to run 2 amps from a single pair of outputs and the amps were --seeing-- each other and were not happy about it.when i was biamping successfully it was through an audible illusions modulus 2b that had 2 pairs of outputs.
how do i build a simple buffer stage so that the 2 amps dont --see-- each other ?
ive searched the archives but could find only mention of some $300+ diy versions that include everything needed to build but i dont need everything.
Follow Ups:
xm-1 xovers sitting on my closet shelf staring right at me !almost as bad as me showing up for my doctors appointment last friday a full week early.
so much for cutting back on the weed.
That'll solve that! Lucky you. I always wanted to try one.
I drive two amps from a passive linestage (Placette) without any issues. I don't think there is anything going on in the AI other than a parallel connection like the one in my old CJ preamp(PV-2AR) that had two sets of outputs. Of course my situation benefits from using two CJ amps with the same input impedance and sensitivity.
This post is made possible by the generous support of people like you and our sponsors: