|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
68.230.67.50
In Reply to: Wire 2 of the same speakers in a cabinet posted by tnc on March 19, 2007 at 18:25:44:
...it increases the system sensitivity. There's a difference. :-)BTW when I did that (doubling the number of drivers, in parallel), my system's output increased exactly 6dB, the theoretical amount. Son of a gun--it worked!
I agree with hollowboy's recommendation to use the 2nd pair of drivers per baffle as bass drivers and also about the large choke. I'd aim for a lowpass filterpoint of NHT 100Hz and probably lower.
-------------------------------------------------------
Tin-eared audiofool and obsessed landscape fotografer.
http://community.webshots.com/user/jeffreybehr
Follow Ups:
Actually, it does. Efficiency is doubled, which results in a 3dB increase in sensitivity. The other 3dB comes from the halved impedance.
...measured into an 8-Ohm load resistor and then into the speaker, while the latter is measured with ONE WATT into the rated impedance of the speaker.Of the 6dB increase in sensitivity, 3dB comes from drawing double the power out of the amp due to halved impedance, and 3dB comes from doubling the cone area. THAT's the 'theoretical amount' I mentioned in my note.
-------------------------------------------------------
Tin-eared audiofool and obsessed landscape fotografer.
http://community.webshots.com/user/jeffreybehr
Efficiency is acoustic power out versus electrical power in, expressed as a percentage. Mutual coupling of two identical drivers (what you refer to as doubling the cone area) doubles the radiating efficiency of the system, which results in a 3dB increase in the voltage sensitivity. The phenomenon is frequency limited, and total efficiency with direct radiators cannot exceed approximately 25% (D.B.Keele, 91st AES convention, AES preprint #3193).
Yes, output increases (6dB) when you parallel the 2nd driver, but now you've driving it with TWO Watts. When one decreases the Voltage to reduce power to 1 Watt, output decreases 3dB but the output is still 3dB higher than it was before we started.So when we parallel an identical driver, efficiency increases 3dB and sensitivity increases a further 3dB.
-------------------------------------------------------
Tin-eared audiofool and obsessed landscape fotografer.
http://community.webshots.com/user/jeffreybehr
This post is made possible by the generous support of people like you and our sponsors: