|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
75.23.6.5
Can anyone suggest a good but cheap power supply for feild coils in the US
Follow Ups:
with the TENTLABS filament suppliesA quote from a happy customer
" A few weeks ago I asked about using the Tentlabs filament power supply for my field coil speakers. Well, I tried them and I have to say that they are best power supply I've used with these speakers "
By the way I'm not affiliated with Tentlabs in any way.
To infinity and beyond!!!
After some time the tentlabs PS induced some noise to the speakers. I don't know why and just quit using them and went back to batteries. Might try them againone of these days.
What would be the skill level needed to assemble one of these?
You need a transformer and an enclosure to put it in. Take the wires from the transformer insert them into the unit. And then take wires to you field coils. (You'd need to discuss with the supplier what current and voltage they need to be set at)
To infinity and beyond!!!
A Constant Current Supply is what you should go for since current is what builds up the field. If you use a constant voltage supply the magnetic field will vary with the temperature of the coil.
CE dc regulated power supply. I use these on a pair of Supravoxes. Model # HY3005D but there are several versions depending upon voltage and current requirements. Check this site out for supply.
I recently asked a question on this Asylum about a suitable battery to power FC tweeters. I only got one joke response, so I gave up on the battery idea. I did some more research and found a "cheap but good" dual output power supply for $99 plus shipping (see link below).I have been using it for the past two weeks and it works great. You can vary the output voltage from 0 - 30V and the current from 0 - 2A. They have other, more powerful models, if you need more voltage and/or current. I checked various output voltages on my DMM and they are very accurate. Also, the digital readouts are really nice and make setup a breeze. Highly recommended!
Gerry
In the process of buying the Fertin 20ex. Would it be easier to go with a SLA battery since I have the ClariT amp with charger?
SLA batteries for Fertin 20EX are highly recommended; I wouldn't use anything else with mine. Do yourself a favor, though: spring for a 26ah battery and a 1ah charger.
Can you describe your setup in more detail becauseI'm no techie.
Thanks
There's not much to it. Hook up the two drivers in parallel to the battery. Red binding posts to red connection on the battery and black binding posts to black connection on the battery, and bob's your uncle. Disconnect when not playing music, and charge after about 6 hours of use assuming a 26ah battery.
So there is no need for a voltage and amp regulator for the battery?
Not unless you want a supply voltage/ current other than that dictated by V=I/R where R=~10ohms (that's about what my field coils measure)...Seriously, it's too simple and it sounds great.
You need to know the resistance of the field coil. This could be anything from several Ohms to several kOhms, which will require voltages from few to several hundred volts. There is no universal power supply that would cover all possible voltage and current requirements.For low resistance coils, 5 V and 12 V computer power supplies may be useful. 500-700 Ohm coils can be powered from a wall outlet through full wave rectifier and RC filter. For kiloOhms, a step-up transformer will be needed.
what field coils you have?
This post is made possible by the generous support of people like you and our sponsors: