|
Audio Asylum Thread Printer Get a view of an entire thread on one page |
For Sale Ads |
74.72.236.228
Ive done a few searches here for laser alignment procedures and Ive found some responses for other players. Ive tested those methods but Im not getting any results with the 333ES. It reads cds and sacds fine once it succesfully reads the first disc. If I stop it and try to get it to start up again it has trouble reading the discs again until I give it a disc it recognizes. It will read the TOC but it wont start to play and I can hear the laser searching.
Follow Ups:
Anyone? Ive seen it discussed for other players but the methods to enter the service menu dont work for this player
...but you must get yourself a full service manual and sit down with it and the machine for a fun time!It says this, but unfortunately in TecnoJaplish:
----------------------------------------
Setting Method of Test ModeTurn the [POWER] switch on while pressing the [ AMS ]
dial and the [TIME/TEXT] button. Release the [TIME/TEXT] button
and the [ AMS ] dial in this order when “TEST MODE
Menu” is displayed on the fluorescent display tube. (If the
[ AMS ] dial is released first, the test mode becomes active
but “TEST MODE Menu” is not displayed)
-------------------------------------------And a little later they write:
-------------------------------------------
CD and SACD (SL) Disc Operation CheckChecking method:
1. Press the [OPEN/CLOSE] button to open the tray and place the test disc *1. The [OPEN/CLOSE] key is disabled immediately after the
machine enters the TEST mode. Be sure to initialize the table.
2. Press the [ AMS ] dial, and the following check will be performed automatically.
3. Finally, the test disc will be ejected and the auto check will finish.
4. “AUTO CHECK OK” will be displayed at successful completion of auto check.
5. Recheck is enabled if the [ AMS ] dial is pressed in step 4. (Also, use this operation when exchanging the test disc)
6. In case of an error during the checking, the check is interrupted automatically and the error is displayed. (Error display example:
“DISC DETECT ERROR”) After error display, “CONT?STOP (J/S)” is displayed. In this case, if the [ AMS ] dial is pressed,
the check where the error occurred is skipped and you can proceed to the next check. Also, if the x button is pressed, the check
finishes and “AUTO CHECK NG” is displayed when even one NG item exists.
*1 Use PATD-012 or YEDS-18 for CD, and SATD-S5 or SATD-S4 for SACD (SL). Using another disc will result in a checking failure.
l-------------------------------------------If this helps - good luck. I personally find some of their instructions almost impossible to follow but with the machine in front of one - it can be understood. I don't deal with this machine so have no practical knowledge.
Again, good luck!
Hello again Allen I cant get it to go into "Auto Check OK". It goes into test mode but doesnt do anything with the cd. Some other tests give me 00000 b9000000 000000FE and messages like that. Any other suggestions? Thanks again!
You are the man. Happy Holidays! Ill report back with the results.
This post is made possible by the generous support of people like you and our sponsors: