|
Vinyl Asylum Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
RE: How easy is it to solder a cartridge clip?
Posted by Gary on October 11, 2020 at 18:54:58:
If you have soldering experience and the right tools it isn't as hard as you might think. I did one of these about six months ago. One of the cartridge wires on my Kuzma Stogi broke off just behind the clip. I did the following:
1 - Uninstalled the cartridge.
2 - Used a little heat from the tip (fine point) of the soldering iron to melt a little of the insulation from the wire tip.
3 - Used an Exacto knife (very carefully) to scrape any remaining insulation from the wire tip.
4 - I have extra cartridge clips. Decided to use one rather than attempt to salvage the original clip. Before soldering made sure the new clip was a good fit for the Koetsu cartridge pins.
5 - Used my third hand tool to hold the wire and and the new clip together.
6 - Soldered the wire to the clip. Those wires are thin and fragile so caution is urged here.
7 - Waited a minute, tested with my multimeter for continuity. Success.
8 - Remounted the cartridge and listened. Both channels now working. No hum, no problem.
Believe me if I can do this anyone with the right tools can.