Vinyl Asylum

Welcome Licorice Pizza (LP) lovers! Setup guides and Vinyl FAQ.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: Getting accurate stylus force gauge readings

Posted by Peter C on March 15, 2017 at 12:10:24:
I'm not calibrating the gauge, just taring it to zero it out. I'm coming up with .6gm figure because if I just take the VTF reading, I get about 2 gm. If I try to tare it to zero first when the cartridge is hovering above, noting that the gauge fluctuates ever more wildly as the cartridge is brought closer and closer until it's just above the weighing platform, not only are my efforts to zero the gauge unsuccessful, but the reading with cartridge on the platform is about 2.6 gm. The Shure gauge confirms that's not correct. Even with it's inaccuracy, it shows roughly 2gm, although it may say 1.8 or 2.1 or something like that - not precise as we know about the Shure gauge.

Apparently the Benz Ruby 3 has a high magnetic field. I also can't use the VPI platter ring because of its ferrous content, which forcibly draws my cartridge to it - it almost bent the stylus.

Also, I think people are getting confused about the materials used in the digital gauge. It doesn't matter that the gauge platform is plastic and aluminum. I'm contending that the strong magnetic pull is interfering with the electronics within the gauge.