|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
RE: What to do with 412 volts
Posted by Eli Duttman on March 8, 2017 at 18:32:57:
I'm inclined to agree with the choke I/P assessment.
A stereo amp is possible, if you go SE. "Fixed" bias, UL mode, KT88 "finals" will get you a fair amount of O/P power. While a little "shorter" primary impedance would be nice, Edcor's CXSE25-2.5K O/P trafo seems to be a possibility.
Use a 5R4 to rectify the 500-0-500 winding and a 5AR4 to rectify the 235-0-235 winding. I'm very dubious about those 5 VAC windings feeding 300Bs. IMO, it's $ to donuts that the vintage trafo was intended for multi-grid O/P tubes. Notice that both suggested vacuum rectifiers draw 2 A. of filament current, which will be safe. Increase the final reservoir capacitance in the LCLC filter.
Phasing up and connecting the 2 6.3 VAC windings in parallel could give you enough current for the KT88 heaters. Get something low cost from AnTek for small signal tube heating.