Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

It helped a little.

Posted by DAK on January 16, 2017 at 20:47:41:
The amp was stable for about 10 minutes then slowly the cathode current of the 6550 started to tick up, and then it picked up speed and i shut it down. I also put in a grid stopper on the input/driver tube. I put the ferrite bead on the wire lead to the grid stopper. it is short not even 2". Maybe i should go with a shielded input wire? The run is short as i said.