|
SET Asylum Single Ended Triodes (SETs), the ultimate tube lovers dream. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
PSU underneath
Posted by andy evans on September 27, 2020 at 02:13:25:
Here's a picture underneath one of the PSUs. Wiring is in 3 dimensions - I'm not fussy about routing wires in straight lines. I use a lot of nylon hexagonal spacers with solder tags at the top to attach parts - you can see them holding some of the capacitors. It means drilling a lot of holes, so not the prettiest to look at on top, but it's very quick and effective. I think of all these amps as prototypes - I could and do change stuff about frequently.
What I like about this system is that I can finish a module outside the chassis. It's just a strip of metal and easy to turn in all directions to work on and solder. When a top plate like this is finished, I can then screw it into the chassis and connect it up. If I want to work on it and change it, I can unscrew it again and just work on that particular module. So easy.
The PSU caps are always standard motor run polypropylene. I use 40uF and 10uF. Cheap and better sounding than electrolytics in my experience.