|
SET Asylum Single Ended Triodes (SETs), the ultimate tube lovers dream. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
RE: HELP: High impedance load for SET amplifier
Posted by Chip647 on August 6, 2020 at 06:57:28:
You will not harm the amp. The 16 ohm tap will be a fine match for the field coil. If you were able to do a frequency sweep to measure the impedance of the speaker it is highly likely that some frequencies would have less than 16 ohms impedance. Speakers are not resistors and the impedance is usually an average number.