Home
AudioAsylum Trader
SET Asylum

Single Ended Triodes (SETs), the ultimate tube lovers dream.

For Sale Ads

FAQ / News / Events

 

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.

You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login


Login to access features only available to registered Asylum Inmates.
    By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username:

The Name that you picked or by default, your email.
Forgot Moniker?

 
 

Examples "Rapper", "Bob W", "joe@aol.com".

Password:    

Forgot Password?

 Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:  
Your Email:  
Subject:  

Message Comments

   

Original Message

RE: Ignore the doubters!

Posted by Garg0yle on September 20, 2015 at 21:58:27:

Hi Dave, nice to hear from you.

Any recommendations for my little experiment?

I was thinking of arbitrarily marking one end of the wires with a silver sharpie, then covering the wire with a sleeve of some sort. I would then place them in a box and shake it up.

If I am able to discern a difference, I will then mark the sleeve with a sharpie to distinguish the better sounding direction.

If I do think I hear a better direction, when I un-sleeve the wires, most should have the original marks on the same ends.

At first I was just going to use some pre terminated RCA cables for convenience, but I think I should have a larger group to sample from, say at least 10 samples.

Any issues performing this experiment at the large signal level? I'm thinking I could avoid potential interference that I may encounter testing un-shielded small signal wires.
(I MIGHT have a long enough length of shielded cable to cut into samples, I won't know for sure until tomorrow)

I also changed my mind about testing phase at this stage in the game, I will see how this first part goes first before proceeding.

Cheers