DIY HiFi Forum

Welcome! Need support, you got it. Or share your ideas and experiences.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

Question about Ella bias supply - 22K pots

Posted by PeterI on January 11, 2014 at 16:07:40:
This a pretty specialized and isolated question. I am looking at the schematic for Ella 3.7. In the bias supply -50VAC is rectified and filtered and sent to 4x 22K pots for output tubes. Does each pot have its own 4.7K resistor to ground?

Bias is supposed to be -36V before the grid resistors. What voltage should be measured at pin 5 (grid) of the EL34 OP tubes?

Thanks for any info.

Peter