Cable Asylum

Interconnects, speaker wire, power cords. Ask the Cable Guys.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

Any Advice for Black Mamba / MPS Hercules Build?

Posted by atkinsonrr on July 24, 2020 at 03:17:26:
My intention is to keep my Eclipse 7 from amp to crossover but rewire crossover, crossover to speaker, and inside speaker. Crossover is all solder connections. Crossover to speaker is solder on the crossover end and low mass banana Au over pure Cu jacks and plugs from Audiophonics that I believe do a good job. So will prob pass on the spades.

I will total up what I need and put my order in for the "bell wire" today. And you are saying use the smaller gauge for both tweeter and mids right? You sure this is gonna be an improvement for body/imaging/detail? It looks kinda pre-historic!