Cable Asylum

Interconnects, speaker wire, power cords. Ask the Cable Guys.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

RE: Oyaide Black Mamba-Sigma V2 Power Cord

Posted by Duster on January 22, 2017 at 11:45:47:
Yes, the ground conductor of the power cord is connected at both ends of the power cord, but the drain wire is only connected to the AC plug, not the IEC connector.

The purpose of the drain wire is to make contact with the copper foil shield along the entire length of the cable. The copper foil shield should be cut back to the end of the cable jacket at both ends so it is not exposed. The drain wire should also be cut back at the IEC connector end of the cable jacket so that it's not exposed. Only the drain wire at the AC plug end of the cable should be exposed in order to connect it to the ground slot of the AC plug.