|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
For Sale Ads |
Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.
Original Message
Dynaco 400 outputs crossed
Posted by jeffl@yorku.ca on December 31, 2020 at 16:36:27:
Hi, When I put a sine wave from a sig. gen. in the right input, it comes out the right output (and only the right output).
When I put the sine wave in the left input, it comes out the left and the right outputs .It is not distorted and the left volume control controls
both outputs.
I have built and installed upgraded pc 28 boards.
I found that IC3 was very hot so I removed it.
Later ,I found that cap. 125 (200mfd., 3v )was totally missing!!
This amp was a kit put together by someone else.
Any help would be appreciated.
Thanks, Jeff