Amp/Preamp Asylum

Looking for a new Amp or Preamp? If you're after tubes, post over here.

Use this form to submit comments directly to the Asylum moderators for this forum. We're particularly interested in truly outstanding posts that might be added to our FAQs.
You may also use this form to provide feedback or to call attention to messages that may be in violation of our content rules.

You must login to use this feature.

Inmate Login

By default, logging in will set a session cookie that disappears when you close your browser. Clicking on the 'Remember my Moniker & Password' below will cause a permanent 'Login Cookie' to be set.

Moniker/Username: The Name that you picked or by default, your email. Forgot Moniker?	Examples "Rapper", "Bob W", "joe@aol.com".
Password:	Forgot Password?
	Remember my Moniker & Password ( What's this?)

If you don't have an Asylum Account, you can create one by clicking Here.

Our privacy policy can be reviewed by clicking Here.

Inmate Comments

From:
Your Email:
Subject:

Message Comments

Original Message

You are correct about the output trannies but not the Power tranny

Posted by airtime on January 5, 2017 at 18:07:08:
Ok the Power tranny is a little beefier but the outputs are about the same. Here is the quote off Bob's page.

2. The new USA made power transformer has a higher stack lamination than the original Dynaco power transformer and is rated
for 120 volts instead of 115 like the old design. The two tube heater legs are rated for 5 amps each instead of 3 amps each
like the old design. This beefed up transformer (which has a bottom plate like the original PA-060 to prevent EMI from
the transformer from reaching the audio circuitry) allows the use of KT88 output tubes in place of the EL34 tubes for
a slightly different tonal presentation. Four heavy duty neoprene isolation mounts are used to attach the transformer to the chassis.

3. The A-470 output transformers are brand new USA made custom production transformers. They use the same interleaved/layer winding
technique as the original cloth lead A-470's and incorporate the same high quality M-6 grain oriented laminations.
They are dimensionally accurate to the original design and have a durable heat resistant black epoxy finish.