|
ANK AudioKits Forum ANK AudioKits support forum |
|
|
|
ANK AudioKits Forum ANK AudioKits support forum |
|
In Reply to: How to convert OTO Phonoe SE into preamp. posted by RGA on September 30, 2009 at 13:27:05:
Don't use the Tape Outputs as they are connected to the wiper of your selector switch ahead of your balance and volume controls and receive the full, unattentuated signal directly from whatever source is selected.
Use the Pre Out connectors if you have them, as they are attentuated by the volume control and are also buffered by the line stage, if your version of Oto has one.
BTW, what monos are replacing the Oto power stage?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: How to convert OTO Phonoe SE into preamp. - Frank E 16:04:38 09/30/09 (9)
- One very important thing . . . - Frank E 16:18:48 09/30/09 (8)
- RE: One very important thing . . . - RGA 00:13:28 10/01/09 (7)
- RE: One very important thing . . . - Frank E 13:32:34 10/01/09 (6)
- RE: One very important thing . . . - RGA 14:23:13 10/04/09 (0)
- RE: One very important thing . . . - R Browne 09:29:21 10/03/09 (1)
- "M1 pre" - Frank E 10:25:41 10/03/09 (0)
- I use the loop for headphone amps - Frihed89 17:37:56 10/02/09 (2)
- Does the OTO have a tape or monitor out? - Frihed89 03:06:58 11/18/09 (0)
- RE: I use the loop for headphone amps - RGA 14:08:49 10/04/09 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
