Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: RE: I could be wrong but... posted by rivervalley817 on February 22, 2021 at 13:45:19:
From my limited understanding the pre-amp "sees" the current loads on each set of outputs as cumulative loads, not independent, isolated loads. If there's too much of an imbalance (ratio of output:input less than 1:10) in the resulting impedance the pre-amp may not be able to efficiently drive the signal to either set of outputs and you can end up with considerable distortion at both ends of the frequency spectrum, especially the bass.
I'm fairly certain that's what was happening to my setup. I may have the technological aspects wrong but putting the buffers into play solved the problem.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I could be wrong but... - tketcham 15:03:51 02/22/21 (4)
- RE: I could be wrong but... - rivervalley817 15:19:36 02/22/21 (3)
- RE: I could be wrong but... - tketcham 15:31:28 02/22/21 (2)
- RE: I could be wrong but... - rivervalley817 15:40:59 02/22/21 (1)
- RE: Dust - tketcham 15:56:02 02/22/21 (0)