Home Vintage Asylum

Classic gear from yesteryear; vintage audio standing the test of time.

biasing setup on Scott 222D question

was poking around on this amp, noted that it has a 10 resistor on the PAIR of output tubes, which means that when you are setting bias, its not between tubes but between tube PAIRS. Wondering if I can change that single 10 by putting 2- 20 ohm resistors in parallel, one to each cathode of each tube where I can measure each tubes cathode current and still have the 10 ohms for the bias setup in the manual. Any ideas/suggestions?


This post is made possible by the generous support of people like you and our sponsors:
  Herbie's Audio Lab  


Topic - biasing setup on Scott 222D question - gkargreen 18:07:37 03/18/17 (4)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.