|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
HiI just picked up an old stereo tube amp without tubes at a ham radio rally (GZ32, 2 x ECC83 & 4 X 6BW6). The chassis is in a bad way but the transformers look ok. The output tubes are marked as 6BW6 and the output transformers are for push pull operation without UL taps. I guess the output transformers must be rated about 15 watts or so with an 8K primary. I am looking to put them into service in an EL84 or similar amplifier. Can anyone point me in the direction of a suitable schematic for a push pull amp without UL screen connections. Can I use these output transformers in triode mode?
Thanks
Martin
This post is made possible by the generous support of people like you and our sponsors:
Topic - Push-pull EL84 or 6BW6 schematic - martinpadams 07:08:00 07/13/03 (13)
- Ratcheer. - Poindexter 09:47:28 07/13/03 (12)
- Re: Ratcheer. - martinpadams 10:59:58 07/13/03 (11)
- Re: Ratcheer. - groverg 21:42:22 07/13/03 (9)
- Imbalance. - Poindexter 09:53:57 07/14/03 (8)
- it is a matter of length - Sector-7G 10:49:19 07/14/03 (7)
- All the girls say so. - Poindexter 12:39:23 07/14/03 (6)
- Re: All the girls say so. - Sector-7G 17:00:09 07/14/03 (5)
- exapmle? - Poindexter 18:56:03 07/14/03 (4)
- Re: exapmle? - dave slagle 19:52:51 07/14/03 (3)
- Ground? - Poindexter 22:37:22 07/14/03 (2)
- Re: Ground? - dave slagle 06:11:12 07/15/03 (1)
- Thank you. - Poindexter 09:02:08 07/15/03 (0)
- Unbalance, 5965's. - Poindexter 11:22:04 07/13/03 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2025, Audio Asylum, all rights reserved ]
