Home Tube DIY Asylum

Do It Yourself (DIY) paradise for tube and SET project builders.

RE: Choke loaded CF

As a general rule, the inductive reactance needs to be five to 10 times the operating impedance of the circuit at the lowest frequency of interest. In the case of a CF, operating impedance is determined by the output Z of the tube. As an example, if the output Z of the tube is 300 ohms, XL should be roughly 3K ohms at 20 Hz. That can be accomplished with a 25H choke. In addition to plate chokes, it's possible to use the primary of inexpensive SE transformers for this. You only need to ascertain the inductance of the winding. As for the total resistance needed to bias the circuit, bypass the cold end of the choke to ground with a good quality capacitor, then add enough resistance in series with the cold end of the choke to equal the desired value.

--------------------------
Buy Chinese. Bury freedom.


This post is made possible by the generous support of people like you and our sponsors:
  Analog Engineering Associates  


Follow Ups Full Thread
Follow Ups
  • RE: Choke loaded CF - Triode_Kingdom 08:14:19 03/07/17 (0)

FAQ

Post a Message!

Forgot Password?
Moniker (Username):
Password (Optional):
  Remember my Moniker & Password  (What's this?)    Eat Me
E-Mail (Optional):
Subject:
Message:   (Posts are subject to Content Rules)
Optional Link URL:
Optional Link Title:
Optional Image URL:
Upload Image:
E-mail Replies:  Automagically notify you when someone responds.