|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
|
|
Tube DIY Asylum Do It Yourself (DIY) paradise for tube and SET project builders. |
|
In Reply to: RE: I would not use wire-wound resistors in grid stopper positions posted by dave slagle on March 4, 2017 at 09:16:39:
It's a question of Q. Will those devices exhibit sufficient dampening at the frequencies over which the tube exhibits a tendency toward instability? I've seen transmitting tubes oscillate when the carbon comps in anode suppressors (the second device you mentioned) were replaced with spiral-wound carbon film. Depending on the tube, the circuit and the physical layout, this can be a tricky thing.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: I would not use wire-wound resistors in grid stopper positions - Triode_Kingdom 11:30:19 03/04/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]
