|
OTL Asylum OTL, Output Transformerless Amplifier User Group. |
|
|
|
OTL Asylum OTL, Output Transformerless Amplifier User Group. |
|
In Reply to: Are you replacing the coupling caps? posted by Ralph on March 17, 2016 at 12:49:30:
....altho I have no HQ caps around that value on hand; my calculator indicates that that load impedance is about 1 Meg-Ohm. Or I could install a new cap at the input feeding the 100K load resistor, and if I'm using only the RCA input, would I also have to add a same-value cap somewhere on the negative half of the balanced-input lead?
Seem to me that having the signal pass thru one pair of caps is only half as bad as having it pass thru 2; yes?
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- Yes I'll replace the couplers if that makes the most sense... - jeffreybehr 14:48:31 03/17/16 (9)
- RE: Yes I'll replace the couplers if that makes the most sense... - Ralph 12:49:03 03/18/16 (0)
- When you are talking about such small parts - Ralph 09:20:13 03/18/16 (7)
- If the load impedance is indeed around 965K, a 0.005uF cap... - jeffreybehr 12:10:19 03/18/16 (6)
- RE: If the load impedance is indeed around 965K, a 0.005uF cap... - Lew 19:08:40 03/18/16 (5)
- The more I (over)think* this, the more I'm tending toward... - jeffreybehr 21:08:47 03/18/16 (4)
- If you are dealing with fragile drivers - Ralph 10:26:47 03/21/16 (3)
- RE: If you are dealing with fragile drivers - jeffreybehr 15:16:12 03/21/16 (2)
- I agree- sounds like you are in good shape nt - Ralph 08:34:26 03/22/16 (1)
- I've subsequently decided, after a discussion that you and I had here... - jeffreybehr 23:42:04 03/25/16 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]