VK Music - Elekit & Triode Japan Forum
Welcome! Need support, you got it. Or share you ideas and experiences.
Tube Hybrid Amp- available on November 15, 2012
 TU-H80 Modification
Although TU-H80 was not made for applying other options, there is a space where the PS-3429 can fit.
It is easy to install it if a hole in the chassis’ aluminum panel is made, but a head of a screw protruding out of the aluminum panel surface is unsightly since the case is nice and smooth.
Therefore, you can affix it with a sponge-coated tape, but eventually this might come off and cause a short. Because of that, the solution is to fasten a screw without the head protruding. Drill a hole to the speaker terminal and then attached it.
It is only the following two types (four total pieces) of modification parts that you need to prepare.
*Small flat head (machine) screws M3×5～10 …2
*Spacers with male and female screws M3×40(～45) …2
(In the image, four 10mm spacers to make 40mm are connected)
(1) Paper pattern for drilling
Click the image and print it out with no reduction or enlargement the size. If it doesn’t print to the actual size, please make reduce or enlarge to proper size.
(Resolution of the picture is set to 150dpi.)
(2) Cut the paper pattern, place it on the speaker terminal and drill the holes.
(In the above picture) Place the paper pattern like this because you will need to drill the holes on the side farthest from the flat terminal.
(In the above picture) After drilling, process the perimeter of the hole to be able to install countersunk screws and spacers.
(In the above picture) Put a slit in the rear panel and feed a USB cable through the slit.
After this, it will be done if H80 is set in an aluminum case as before.
This post is made possible by the generous support of people like you and our sponsors:
Topic - RE:Elekit TU-H80 - vkung 19:22:53 11/01/12 (0)