Home Bottlehead Forum

Welcome! Need support, you got it. Or share you ideas and experiences.

There just isn't enough bolt to work ...

Thanks for all the advice, but I re-measured the exposed bolt and it is only 1/4" in length. When you add the shoulder washer and the lock washer, there is absolutely no room for a nut - trust me on this. Even when I follow everyone's input, I wouldn't be able to turn the nut even one revolution. I'm doing all this when the transformer isn't even on the plate ... the plate adds a little bit of additional thickness (even when the shoulder washers are properly seated) so installing the washers or the solder lug is out of the question. In theory, I could sand each of the shoulder washers to make them thinner, but that seems to counter intuitive.

I'll call Bottlehead today and see what they can tell me ....

This post is made possible by the generous support of people like you and our sponsors:
  Sonic Craft  

Follow Ups Full Thread
Follow Ups

You can not post to an archived thread.