|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
|
|
Amp/Preamp Asylum Looking for a new Amp or Preamp? If you're after tubes, post over here. |
|
In Reply to: 32 mV DC: defective or acceptable? posted by dave789 on March 15, 2017 at 23:38:49:
Test it with no load and after it has warmed up for about 5 minutes.
Honestly even my cheaper amps can be set to 0mv. Sounds like some poor QC on the part of the factory line person doing that settings.
Check it while the stereo is "cold" and then again after it has been on for an hour. If there is a significant swing you got some problems.
This post is made possible by the generous support of people like you and our sponsors:
Follow Ups
- RE: 32 mV DC: defective or acceptable? - airtime 09:08:20 03/16/17 (2)
- same without load. nt - dave789 16:02:39 03/16/17 (0)
- no DC adjustment pot on the service manual - dave789 15:39:41 03/16/17 (0)
Top of Page ]
[ Contact Us ]
[ Support/Wish List ]
[ Copyright © 2024, Audio Asylum, all rights reserved ]